Phase 5 Fiberglass Polish (16 oz)

Regular price $56.99 Sale price $41.99 excl. GST $36.51
or 6 weekly interest-free payments from $6.99 with Laybuy

Product: #GAP11416
9 in stock

Phase 5 Fiberglass Polish is an all-in-one scratch and swirl remover that cuts away deep swirl marks and scratches, then restores a mirror shine to fiberglass and gel coat finishes in one step.

Use This Polish To: 

  • Compound and polish in one easy step
  • Achieve the highest level of optical clarity
  • Save time and money with a one step
  • Restore a perfect finish in less time
  • Polish in just one pass

Combines Multiple Steps Into One

When fiberglass does get scratched, swirled, and faded from UV solar rays, it needs a tough compound to remove swirls and marks that mar the finish. Phase 5 uses a hybrid abrasive compound to cut away deep swirl marks and scratches, then refine the finish to restore deep gloss, pure reflection, and brilliant shine.

No Fillers For Real Results

When fiberglass does get scratched, swirled, and faded from UV solar rays, it needs a tough compound to remove swirls and marks that mar the finish. Phase 5 uses a hybrid abrasive compound to cut away deep swirl marks and scratches, then refine the finish to restore deep gloss, pure reflection, and brilliant shine without filling in or hiding swirls, scratches, or defects.

How To Use:
Application by Hand:
Mist desired pad to be used with Chemical Guys Polishing Pod Conditioner moisten the foam and reduce friction.
Apply a nickel size amount of Phase 5 Polish to the applicator.
It is always recommended to apply polish out of direct sunlight.
Work polish in a back and forth, work in 2 x 2 sq. foot sections until the entire surface is done.

Note: General Hand application of Phase 5 Polish by hand will remove light oxidation and minor imperfections while enhancing gloss. Doing the work by hand will not deliver the same superior results achievable with a PC or Rotary. For paint correction, it is always recommended to use a polisher.

Application by Machine:
Mist desired pad to be used with Chemical Guys Polishing Pad Conditioner to moisten the foam and reduce friction.
Apply a nickel size amount of Phase-5 Polish to the applicator.
Always make sure the surface to be compounded is clean and dry.
If surface is freshly or recently painted, always allow time to properly cure.
It is always recommended to apply polish out of direct sunlight.
Though product will work great even in the sun, maximum work time is achieved out of direct sunlight.
Apply a 4-6 inch line of polish to the surface.
With the polisher turned off, spread the polish over about a 2 x 2 sq. ft. area.
Polish at 1200-1800 RPM on rotary polisher or 5000-6000 OPM for Dual-Action polisher.
Work area slowly across and then up and down the area.
Always double check your work after several passes to assure proper results.
Wipe surface area with a lightly damp microfiber towel.
Always apply a wax or sealant after compounding or polishing.
Chemical Guys recommends Jet Seal for maximum protection, durability and wet mirror shine.